1. عرض جديد خاص بالإشتراك في سيرفر الأحلام و IPTV

Error Codes

الموضوع في 'هيوماكس - Humax' بواسطة BAD_BOY, بتاريخ ‏25 سبتمبر 2006.

حالة الموضوع:
مغلق
  1. BAD_BOY

    BAD_BOY عضو نشيط

    إنضم إلينا في:
    ‏1 سبتمبر 2006
    المشاركات:
    277
    الإعجابات المتلقاة:
    2
      25-09-2006 05:48
    HERE R SOME ERROR CODES



    E-HC/bC -- Incorrect header block(CRC-16)
    The software is damaged. Re-download the software

    E-dC -- Incorrect data block(CRC-16)
    The software is damaged. Re-download the software

    E-Hn/bF -- Invalid HDF version
    This error can occur when you attempt to download Non-Superset STB software to Superset or Vice-Versa. Please check the STB model and the software

    E-Id -- Invalid system ID
    This error can occur when you attempt to download F1 software to F1-CI. Please check the STB model and the software

    E-AC -- Incorrect application CRC-32
    Download latest version of application software

    E-ut -- UART RX/TX time out
    There is communication problem between source and target
    1Check whether the S/W is compressed or not and check whether you used the proper download tool for the software
    2Reduce the download speed and try to download again
    3Switch STB main power off/on and try to download again
    4Reboot the PC and try to download again

    E-Ad -- Invalid address
    Humax created the hdf file with an invalid address. Please notify Humax of this error and wait until Humax releases fixed software.

    E-Ao -- Invalid offset address for upload(Odd offset)
    There was a mistake when Humax made hdf file from binary file. Please let Humax know immediately and wait for a fix

    E-Ft -- Flash program time out
    The flash memory in the STB seems damaged. Please try to download again. If you fail agian, send the receiver back to Humax to have the flash memory device replaced

    E-It/Et -- EEPROM program time out
    The EEPROM in the STB seems damaged. Please try to download again. If it fails again, replace the EEPROM device

    E-FE -- Fail compare after flash write
    Flash memory is damaged. Return the main board( CPU Board)

    E-HF -- Invalid HDF Format
    Humax made the hdf file with wrong version. Please notify Humax of this error and wait until a fix is released

    E-Fn -- Invalid flash device
    Flash memory is defect. Need to change the flash memory so please return the Main Board
     
حالة الموضوع:
مغلق

مشاركة هذه الصفحة

جاري تحميل الصفحة...